Aerodynamic Characteristics of a Powered Semispan Tilting-shrouded-propeller VTOL Model in Hovering and Transition Flight

Download or read book Aerodynamic Characteristics of a Powered Semispan Tilting-shrouded-propeller VTOL Model in Hovering and Transition Flight written by Kenneth W. Goodson and published by . This book was released on 1962 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt: "An investigation of the aerodynamic characteristics of a powered semispan tilting-shrouded-propeller configuration has been conducted in the 17-foot test section of the Langley 300-MPH 7- by 10-foot tunnel. The wing had an aspect ratio of 2.67 (based on wing span of 60 inches), a taper ratio of 0.67, and an NACA 2418 airfoil section with a 15-inch-diameter shrouded propeller mounted on the tip. The test results show that large nose-up pitching moments are obtained at transitional speeds of about 40 knots and duct angle of about 70°. Decelerating flight procedures further increases in the nose-up moment. Ground proximity reduces the nose-up pitching moments. The large nose-up moments can be trimmed by use of duct-exit control vanes. The results show that unloading the duct (shroud) by flying at a wing angle of attack of 15° reduces the power required by about 30 percent at 50 knots. Duct-lip stall produces large increases in power required. The results in general show that full-scale aerodynamic simulation can be made with small-scale wind-tunnel models if duct-lip separation at low Reynolds numbers is avoided."--Summary.